Users Guide

boot write net config retries
Set the number of retries for network boot configuration failure.
Syntax boot write net config retries <int>
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Example
BOOT_USER # boot write net config retries 2
Updated number of Network Boot Config retries to 2
BOOT_USER #
boot zero
Erase the configured primary, secondary, or default boot image parameters. If you erase all three parameters, the S6000 switch boots
from its internal Flash.
Syntax
boot zero primary | secondary | default}
Parameters
primary
Enter the keyword primary to configure the boot parameters used in the first attempt to
boot the system.
secondary
Enter the keyword secondary to configure boot parameters used if the primary operating
system boot selection is not available.
default
Enter the keyword default to configure boot parameters used if the secondary operating
system boot parameter selection is not available. You can configure this option to any of
the available type, for example flash/usb/ftp/tftp.
Defaults None
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
Boot Command Line Interface 313