Users Guide

NOTE: You can use this attribute on a specific VRF to remove history routes
corresponding to that VRF. You can also use this attribute to return the
suppressed routes corresponding to a specific VRF to an active state.
peer-group-name Enter the peer group name to reset the BGP sessions within that peer group.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to reset
ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to reset ipv4
unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to reset ipv6
unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft configuration.
in Enter the keyword in to re-configure soft inbound updates.
out Enter the keyword out to re-configure soft outbound updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Border Gateway Protocol 351