Users Guide

peer-group-name Enter the name of the peer group to set the default route of all routers in that peer
group.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-originate command
configured, the software does not apply the set filters in the route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the neighbor default-originate
command, the command checks for the existence of the route in BGP RIB.
Route-map configuration on a BGP peer or peer group works only when the LOC-RIB contains at least one route.
When you apply a default route to a BGP peer or peer group using the neighbor default-originate
command, changes to the configured default route-map are applied to the BGP peer or peer group only after a
delay of 15 seconds. As a result, you must wait for a period of 15 seconds before manually resetting BGP using the
clear ip bgp command.
In case of eBGP, the neighbor default-originate command does not support extended-community as a
non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already configured with these settings.
In order that settings corresponding to the neighbor default-originate command take effect, you must
execute the clear ip bgp command immediately after you execute the neighbor default-originate
command.
Border Gateway Protocol 367