Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information When you enable failover, BGP keeps track of IP or IPv6 ability to reach the peer remote address and the peer
local address. Whenever either address becomes unreachable (for example, no active route exists in the routing
table for the peer IP or IPv6 destination/local address), BGP brings down the session with the peer.
Related Commands
• show ip bgp neighbors — display information on the BGP neighbors.
neighbor local-as
To accept external routes from neighbors with a local AS number in the AS number path, configure Internal BGP (IBGP) routers.
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-prepend]
To return to the default value, use the no neighbor {ip-address | peer-group-name} local-as
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the advertisement interval for all routers in the
peer group.
as-number Enter the AS number to reset all neighbors belonging to that AS. The range is from 0 to
65535 (2 byte), from 1 to 4294967295 (4 byte) or from 0.1 to 65535.65535 (dotted
format).
no prepend Specifies that local AS values do not prepend to announcements from the neighbor.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Border Gateway Protocol 371