Users Guide
received-routes
[network [network-
mask]
(OPTIONAL) Enter the keywords received-routes then either the network address
(in dotted decimal format) or the network mask (in slash prefix format) to view all
information received from neighbors.
NOTE: Configure the neighbor soft-reconfiguration inbound
command prior to viewing all the information received from the neighbors.
denied-routes
[network [network-
mask]
(OPTIONAL) Enter the keywords denied-routes then either the network address (in
dotted decimal format) or the network mask (in slash prefix format) to view all
information on routes denied via neighbor inbound filters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the ADDPATH
parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Added the detail option. Output now displays the default MED value.
7.2.1.0 Added the received and denied route options.
6.3.10 The output is changed to display the total number of advertised prefixes.
Usage Information
After a peer reset, the contents of the notification log messages is displayed in hex values for debugging.
The neighbor information that this command displays does not include counts corresponding to ignored prefixes
and updates. However, the martian case is an exception where neighbor information corresponding to ignored
updates is displayed.
BGP shows the exact information that is exchanged between the BGP peers. It also indicates whether or not this
information is received by the BGP peer.
The following describes the show ip bgp neighbors command shown in the following examples.
418 Border Gateway Protocol