Users Guide

Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system
for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks cannot be
reallocated. Only 13 number of blocks can be configured by the user .
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have changed
the NVRAM content, use the command reload conditional nvram-cfg-change.
cam-acl-egress
Allocate CAM for egress ACLs.
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number Allocate space to each CAM region. The total space allocated must equal 4. The ipv6acl
range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
440 Content Addressable Memory (CAM)