Users Guide

Usage Information
When a new set of protocols is configured in the protocol-group over an existing set of protocols, the new set
replaces the existing list of protocols in the protocol-group.
Example
Dell#configure terminal
Dell(conf)#cpu-protocol-group PG0
Dell(conf-cpu-protocol-group)#protocol-list 802dot1x , arp-req , arp-rsp
Dell(conf-cpu-protocol-group)#show config
!
cpu-protocol-group PG0
protocol-list 802dot1x , arp-req , arp-rsp
Dell(conf-cpu-protocol-group)#
queue-length
Configures queue length.
Syntax
queue—length queue-length-value
Use the no queue-length command to remove the queue length configuration.
Command Modes QOS-POLICY-INPUT
Parameters
queue-length-value Enter the queue length value you want to configure. The range is from 0 to 235.
Default The default value is 235.
Command History
Version Description
9.11.0.0 Introduced on the S6000, S6000–ON, Z9100–ON, and S6100–ON.
Usage Information
The queue-length takes effect only if the qos-policy is associated with a copp-policy.
Example
Dell(conf)#qos-policy-input QP1 cpu-qos
Dell(conf-in-qos-policy-cpuqos)#queue-length 235
%Info: queue-length will take effect only when qos-policy is associated with a
CoPP profile.
Dell(conf-in-qos-policy-cpuqos)#show conf
!
qos-policy-input QP1 cpu-qos
queue-length 235
Dell(conf-in-qos-policy-cpuqos)#
service-policy rate-limit-cpu-queues
Apply a policy map for the system to rate limit control traffic on a per-queue basis.
Syntax
service-policy rate-limit-cpu-queues policy-name
452 Control Plane Policing (CoPP)