Users Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
ip tcp initial-time
Define the wait duration in seconds for the TCP connection to be established. This command is supported on the , , , and platforms.
Syntax
ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as 8 seconds, use the no ip tcp
initial-time command.
Parameters
<8-75> Wait duration in seconds for the TCP connection to be established.
Command Modes
CONFIGURATION
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000, and Z9000 platforms.
Usage Information You can configure the amount of time for which the device must wait before it attempts to establish a TCP
connection. Using this capability, you can limit the wait times for TCP connection requests. Upon responding to
IPv4 Routing 759