Administrator Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim interface command shown in the following example.
Field Description
Address Lists the IP addresses of the interfaces participating in PIM.
Interface List the interface type, with either slot/port information or ID (VLAN or Port Channel), of
the interfaces participating in PIM.
Ver/Mode Displays the PIM version number and mode for each interface participating in PIM:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of PIM neighbors discovered over this interface.
Query Intvl Displays the query interval for Router Query messages on that interface (configured with
ip pim query-interval command).
DR Prio Displays the Designated Router priority value configured on the interface (use the ip
pim dr-priority command).
DR Displays the IP address of the Designated Router for that interface.
The show ip pim interface command does not display information corresponding to the loop-back
interfaces.
Example
DellEMC# show ip pim interface
Address Interface Ver/ Nbr Query DR DR
Mode Count Intvl Prio
165.87.34.5 Te 1/10/1 v2/S 0 30 1 165.87.34.5
10.1.1.2 Vl 10 v2/S 1 30 1 10.1.1.2
20.1.1.5 Vl 20 v2/S 1 30 1 20.1.1.5
165.87.31.200 Vl 30 v2/S 1 30 1 165.87.31.201
DellEMC#
show ip pim neighbor
View PIM neighbors.
S6000–ON
Syntax
show ip pim [vrf vrf-name] neighbor
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
PIM-Sparse Mode (PIM-SM) 1133