Administrator Guide

Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the C9010, S3048-ON, S3100 Series, S4048-ON, S4048T-ON, S6000-ON,
S6010-ON, S6100-ON, Z9100-ON.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces
contain the same designated router priority value, the interface with the largest interface IP address becomes the
designated router.
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The range is
from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
1142 PIM-Sparse Mode (PIM-SM)