Administrator Guide

committed-rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is
50.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps.
The range is from 0 to 40000.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to police traffic to those specific
VLANs. The range is from 1 to 4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
NOTE: Per Port rate police is supported for Layer 2 tagged and untagged switched traffic and for
Layer 3 traffic. Per VLAN rate police is supported on only tagged ports with Layer 2 switched
traffic.
S-Series
On one interface, you can configure the rate police command for a VLAN or you can configure the rate
police command for an interface. For each physical interface, you can configure three rate police
commands specifying different VLANS.
rate-shape
Shape the traffic output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
1186 Quality of Service (QoS)