Administrator Guide

• Use the no deny icmp {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
type Enter the ICMP packet type. The following types are available:
For IPv4:
echo count
echo-reply count
host-unreachable count
host-unknown count
network-unknown count
net-unreachable count
packet-too-big count
parameter-problem count
port-unreachable count
source-quench count
time-exceeded count
For IPv6:
echo count
echo-reply count
nd-ns count
nd-na count
packet-too-big count
parameter-problem count
time-exceeded count
port-unreachable count
The ICMP packets cannot be filtered using mirroring ACL.
ttl
Enter the keyword ttl to deny a packet based on the time to live value. The range is
from 1 to 255.
operator Enter one of the following logical operand:
• eq(equal to) — matches packets that contain a ttl value that is equal to the specified
ttl value.
• neq(not equal to) — matches packets that contain a ttl value that is not equal to the
specified ttl value.
• gt(greater than) — matches packets that contain a ttl value that is greater than the
specified ttl value.
• lt (less than) — matches packets that contain a ttl value that is less than the
specified ttl value.
• range(inclusive range of values) — matches packets that contain a ttl value that
falls between the specified range of ttl values.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
192 Access Control Lists (ACL)