Administrator Guide
NOTE: This command also enables you to view information corresponding to a range of ports.
However, for Open Networking (ON) platforms the notation for specifying port range in the
command is different from how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if
you want to display information corresponding to all ports between 1 and 4, specify the port
range as show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-type 1/1/1 -
1/1/4.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Enabled to display the command output even without enabling DCB.
9.9(0.0) Added support to display the interface configurations corresponding to a range of ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can use this command even without enabling DCB.
Example
(Summary)
DellEMC#show int te 1/1/1 pfc statistics
Interface TenGigabitEthernet 1/1/1
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
-----------------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
ETS Commands
The following ETS commands are supported on the Dell EMC Networking OS.
NOTE:
Before configuring ETS, assign the etsacl space. using the cam-acl l2acl 2 ipv4acl 0 ipv6acl 0
ipv4qos 2 l2qos 0 l2pt 0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command.
Data Center Bridging (DCB) 465