Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the C9010.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.9(0.0) Introduced on the Z9500.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor [vrf vrf-name] {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor [vrf vrf-
name] {ipv6-address} {interface interface} command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to install IPv6 routes in
that VRF.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
interface interface Enter the keyword interface then the interface type and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel interface number.
The range is from 1 to 16383.
hardware_address Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Neighbor Discovery Protocol (NDP) 969