Service Manual

interface (IPv4 only) Enter the outgoing interface for multicast packets. Enter the IP address
in A.B.C.D format.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0)P5 Introduced on the S4048–ON.
9.8(0.0)P2 Introduced on the S3048–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
Added support for the outgoing-interface option for link-local IPv6
addressing on the S4820T.
8.3.12.0 Added support for the outgoing-interface option for link-local IPv6
addressing on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the ExaScale.
8.4.1.0 IPv6 pinging available on management interface.
8.3.1.0 Introduced extended ping options.
8.2.1.0 Introduced on the E-Series ExaScale (IPv6).
8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
7.9.1.0 Introduced VRF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
112
Control and Monitoring