Service Manual

policy-map-input
Create an input policy map.
S6000–ON
Syntax
policy-map-input policy-map-name cpu-qos | [layer2] [cpu-qos]
To remove an input policy map, use the no policy-map-input policy-map-name cpu-qos |
[layer2] [cpu-qos] command.
Parameters
policy-map-name Enter the name of the policy map in character format (32 characters
maximum).
cpu-qos Enter the cpu-qos keyword to assign this ACL to control plane trac only.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The
default is Layer 3.
cpu-qos (OPTIONAL) Enter the keyword cpu-qos to create an input policy to be used to
rate-limit control-plane trac (CoPP).
Defaults Layer 3
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Expanded to add support for Layer 2.
6.1.1.1 Introduced on the E-Series.
Usage Information The input policy map is used to classify incoming trac to dierent ows using class-map, QoS policy, or
incoming packets DSCP. This command enables Policy-Map-Input Conguration mode (conf-policy-map-in).
When you congure an input policy map for CoPP, you must enter the keyword cpu-qos .
1168
Quality of Service (QoS)