Service Manual

Note: You must set the IP address of the designated download port before you execute this command.
Otherwise, an second statement message alerts you that the conguration cannot proceed.
shows the rst eld after you enter boot change primary. At this point:
• Press Enter to accept the information already congured, or
• Change that information. To do so, press the . (period) key and enter new information. After you enter
the information, press Enter.
Example
BOOT_USER # boot change primary
boot device : ftp
shows the completed command:
BOOT_USER # boot change primary
'.' = clear field; '-' = go to previous field
boot device : ftp
file name : tt/latestlabel
Server IP address : 10.16.1.200
username : amsterdam
password : ******
BOOT_USER #
To view the current boot conguration, use the show bootvar command.
Related Commands show_bootvar — Display boot conguration information.boot_zero — Remove the primary, secondary, or
default boot image conguration.
boot message
Use this command to enable/disable boot logs during reload.
Syntax
boot message on | o
Parameters
on Enter the keyword on to turn on boot logs during reload.
o
Enter the keyword o to suppress the boot logs during reload.
NOTE: By default, watchdog is disabled.
Defaults None
Command Modes BOOT_USER
Command History
Version 9.0.2.0 Introduced on the S6000.
Example
BOOT_USER #boot message
boot messages off
BOOT_USER #
Boot Command Line Interface
301