Service Manual

deny bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to deny incoming or outgoing trac.
Syntax
deny bandwidth
To disable this setting, enter the no deny bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for denying trac. The range is from 0 to 102400.
Defaults N/A
Command Modes EXTENDED COMMUNITY LIST
Command History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series and Z9500.
Related Commands permit bandwidth – specify link band width extended-community attribute as the matching criteria to
permitting incoming or outgoing trac..
description
Enter a description of the BGP routing protocol
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the BGP protocol (80 characters maximum).
Defaults none
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
348
Border Gateway Protocol