Service Manual

Version Description
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Summary)
Dell#show int te 1/1/1 pfc statistics
Interface TenGigabitEthernet 1/1/1
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
------------------------------------------------------
-
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The
range is from 1 or 2.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB)
447