Service Manual

Usage Information
By default, iSCSI is enabled on the unit and the ow control is enabled on all of the interfaces. It is also acts
as defaults when the link-level ow control is enabled on one or more interfaces.
Enables priority ow control or enhance transmission selection on interface.
Related Commands dcb <ets | pfc> enable — enable priority ow control or enhanced transmission selection on interface.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port[/subport]
Parameters
port-type Enter the keywords port-type then the slot/port information. Enter the subport
number if a 40G port is fanned-out into 10G ports.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
show interface ets
Displays the ETS conguration applied to egress trac on an interface, including priority groups with priorities and bandwidth
allocation.
Syntax
show interface port-type slot/port[/subport] ets {summary | detail}
Parameters
port-type slot/
port[/subport] ets
Enter the port-type slot and port ETS information. Enter the subport number if a
40G port is fanned-out into 10G ports.
{summary | detail} Enter the keyword summary for a summary list of results or enter the keyword
detail for a full list of results.
NOTE: This command also enables you to view information corresponding to a range of ports.
However, for Open Networking (ON) platforms the notation for specifying port range in the
command is dierent from how you specify in non-ON platforms.
•
For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want
to display information corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1 - 4.
448
Data Center Bridging (DCB)