Service Manual

show ip igmp snooping groups
Display snooping related information for all the IGMP groups, interface or one group of one interface.
Syntax
show ip igmp snooping groups [group-address [detail] | detail | interface
[group-address [detail]]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal format to view information
on that group only.
interface (OPTIONAL) Enter the interface type and slot/port[subport] information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For a port channel interface, enter the keywords port-channel then a
number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the IGMPv3 source
information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, Z9000, and Z9500.
Usage Information This command displays the IGMP database, including congured entries for either all groups on all
interfaces, all groups on specic interfaces, or specic groups on specic interfaces.
The following describes the show ip igmp groups command shown in the following example.
Field Description
Group Address Lists the multicast address for the IGMP group.
Interface Lists the interface type, slot and port number.
Mode Displays the IGMP version used.
Uptime Displays the amount of time the group has been operational.
610
Internet Group Management Protocol (IGMP)