Service Manual

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to congure them, refer to the Virtual LAN (VLAN)
Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP
ACLs are supported. For more information, refer to the Access Control Lists (ACL) chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are congured on the switch, spanning-tree protocols cannot be enabled
simultaneously.
Example (Single
Range)
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related Commands
interface — congures a physical interface.
interface loopback — congures a loopback interface.
interface null — congures a null interface.
interface port-channel — congures a port channel group.
show vlan — displays the current VLAN conguration on the switch.
shutdown — disables/enables the VLAN.
tagged — adds a Layer 2 interface to a VLAN as a tagged interface.
untagged — adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled, use the
no intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Not congured
634
Interfaces