Service Manual

Layer 2
Overhead
Link MTU and IP MTU Delta
Untagged Packet
with VLAN-Stack
Header
22 bytes
Tagged Packet with
VLAN-Stack
Header
26 bytes
negotiation auto
Enable auto-negotiation on an interface.
Syntax
negotiation auto
To disable auto-negotiation, use the no negotiation auto command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Usage Information
This command is supported on C-Series, S-Series, and E-Series (TeraScale and ExaScale) 10/100/1000
Base-T Ethernet interfaces.
The no negotiation auto command is only available if you rst manually set the speed of a port to
10Mbits or 100Mbits.
640
Interfaces