Service Manual
• auto-negotiation disabled speed 100
• auto-negotiation enabled* speed 1000 or auto
Port 1
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
• Up at 1000 Mb/s
• Up at 100 Mb/s
• Up at 100 Mb/s
• Down
• Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port congured this way is identied as a hybrid
port in report displays.
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode
hybrid command.
Defaults non-hybrid
Command Modes INTERFACE (conf-if-interface-slot/port[/subport])
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
642
Interfaces