Service Manual

Command History
Version Description
9.7(0.0) Introduced on the S6000 and S6000–ON.
Example
Dell#show system stack-unit 1 quad-port-profile
Configured fan out profile ports in stack-unit 1
Configured Activated
2 2
4 4
6 6
8 8
9 9
10 10
11 11
12 12
13 13
14 14
15 15
16 16
17 17
18 18
19 19
20 20
21 21
22 22
23 23
24 24
25 25
27 27
29 29
31 31
Dell(conf)#stack-unit 1 port 24 portmode quad
Warning: Enabling quad mode on stack-unit 1 port 24. Please verify whether
the configs related to interface Fo 1/24 are cleaned up before proceeding
further.
[confirm yes/no]:yes
Dell(conf)#00:02:24: %STKUNIT1-M:CP %IFMGR-5-DYNAMIC_FANOUT: Port 24 in
slot 1 has been fanned-out >>>>>
Dell(conf)#00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP
inserted in slot 1 port 24/2
00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted in
slot 1 port 24/3
i00:02:27: %S6000-ON:1 %IFAGT-5-INSERT_OPTICS_QSFP: Optics QSFP inserted
in slot 1 port 24/4
Related Commands
stack-unit portmode — splits a single 40G port into four-10G ports
stack-unit quad-port-prole
Congures the list of dynamic fan-out capable ports.
Syntax
stack-unit [stack-unit number] quad-port-profile [default|<1–32>]
To remove the quad-port conguration, use the [no] stack-unit[stack-unit number] quad-
port-profile [default|<1–32>]command syntax.
Parameters
stack-unit
number<1–32>
Enter the port number. The range is from 1 to 6.
The range of the default ports are separated by —,
Defaults 2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31
660
Interfaces