Service Manual

MTU 2000, the Port Channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for
IP MTU.
When an interface is removed from a Port Channel with the no channel-member command, the
interface reverts to its conguration prior to joining the Port Channel.
An interface can belong to only one Port Channel.
You can have 16 interfaces per Port Channel on the S-Series and Z-Series. The interfaces can be located on
dierent line cards but must be the same physical type and speed (for example, all 1-Gigabit Ethernet
interfaces). However, you can combine 100/1000 interfaces and GE interfaces in the same Port Channel.
If the Port Channel contains a mix of interfaces with 100 Mb/s speed and 1000 Mb/s speed, the software
disables those interfaces whose speed does not match the speed of the rst interface congured and
enabled in the Port Channel. If that rst interface goes down, the Port Channel does not change its
designated speed; disable and re-enable the Port Channel or change the order of the channel members
conguration to change the designated speed. If the Port Channel contains a mix of interfaces with 100
Mb/s speed and 1000 Mb/s speed, the software disables those interfaces whose speed does not match the
speed of the rst interface congured and enabled in the Port Channel. If that rst interface goes down, the
Port Channel does not change its designated speed; disable and re-enable the Port Channel or change the
order of the channel members conguration to change the designated speed. For more information about
Port Channels, refer to the Dell Networking OS Conguration Guide.
Related Commands
description — assigns a descriptive text string to the interface.
interface port-channel — creates a Port Channel interface.
shutdown — disables/enables the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identies this LAG fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG number. Enter this
keyword/variable combination twice, identifying the two paired LAGs.
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces
675