Service Manual
brief (OPTIONAL) Enter the keyword brief to display only the port channel number,
the state of the port channel, and the number of interfaces in the port channel.
description (OPTIONAL) Displays the port-channel information with description.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Added support to display the interface congurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series. Modied to display the LAG failover group status.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following describes the show interfaces port-channel command shown in the following
example.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the LAG’s LAG fate-
sharing group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned MAC address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group (“Failover-group”).
Internet address... States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays the interface’s line speed. For a port channel interface, it is the line speed
of the interfaces in the port channel.
680
Interfaces