Service Manual

gre-ipv4 | mac-in-
mac]}
• ipv4-over-ipv4 — Use ipv4-over-ipv4 eld in hash calculation.
• ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 eld in hash calculation.
• mac-in-mac — Use mac-in-mac eld in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask | {ipv6-address
prefix-length}}{forwarding-router-address | managementethernet | fortyGigE
| vlan | gigabitethernet | tengigabitethernet} command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prex format) of the
destination subnet.
ipv6-address prex-
length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prex format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prex length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
724
IPv4 Routing