Service Manual

the limit is reached, additional routes will not be allowed into the RTM ( route table
manager ) itself.
warning-only When the warning-only option is used, a syslog message will be thrown when
maximum number of dynamic IPv6 routes reaches the limit. Additional dynamic
IPv6 routes will still be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes CONFIGURATION-VRF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500.
Usage Information
If the maximum IPv6 route limit is not specied for a VRF (valid range is from 1 to 8000), then it has
unlimited space that extends to the maximum number of entries allowed for the system. This command is
not applicable to the default and management VRFs.
show cam-ipv6 extended-prex
Display the current settings and next-boot settings for cam-ipv6 extended-prex conguration. Display the cam-ipv6 extended-
prex conguration.
Syntax
show cam-ipv6 extended-prefix
Defaults None
Command Modes
EXEC
EXEC Privilege
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage Information You can use this command to view the number of supported extended prex entries in LPM congured. The
output also displays the current applied value and the new value that is applicable after the reboot of the
device.
754
IPv6 Basics