Users Guide

With this feature, you can create larger-capacity interfaces by utilizing a group of lower-speed links. For example, you can build a 50-

Gigabit interface by aggregating five 10-Gigabit Ethernet interfaces together. If one of the five interfaces fails, traffic is redistributed

across the remaining interfaces.

Port Channel Implementation

Dell Networking OS supports static and dynamic port channels.

• Static — Port channels that are statically configured.

• Dynamic — Port channels that are dynamically configured using the link aggregation control protocol (LACP). For details, see Link

Aggregation Control Protocol (LACP).

There are 4096 port-channels with 16 members per channel.

As soon as you configure a port channel, Dell Networking OS treats it like a physical interface. For example, IEEE 802.1Q tagging is

maintained while the physical interface is in the port channel.

Member ports of a LAG are added and programmed into the hardware in a predictable order based on the port ID, instead of in the order in

which the ports come up. With this implementation, load balancing yields predictable results across device reloads.

A physical interface can belong to only one port channel at a time.

Each port channel must contain interfaces of the same interface type/speed.

Port channels can contain a mix of 1G/10G/40G. The interface speed that the port channel uses is determined by the first port channel

member that is physically up. Dell Networking OS disables the interfaces that do not match the interface speed that the first channel

member sets. That first interface may be either the interface that is physically brought up first or was physically operating when interfaces

were added to the port channel. For example, if the first operational interface in the port channel is a Tengigabit Ethernet interface, all

interfaces at 10000 Mbps are kept up, and all other interfaces that are not set to 10G speed or auto negotiate are disabled.

Dell Networking OS brings up the interfaces that are set to auto negotiate so that their speed is identical to the speed of the first channel

member in the port channel.

Interfaces in Port Channels

When interfaces are added to a port channel, the interfaces must share a common speed. When interfaces have a configured speed

different from the port channel speed, the software disables those interfaces.

The common speed is determined when the port channel is first enabled. Then, the software checks the first interface listed in the port

channel configuration. If you enabled that interface, its speed configuration becomes the common speed of the port channel. If the other

interfaces configured in that port channel are configured with a different speed, Dell Networking OS disables them.