Users Guide

• update the ARP table of other nodes on the network in case of an address change
In the request, the host uses its own IP address in the Sender Protocol Address and Target Protocol Address fields.
Enabling ARP Learning via Gratuitous ARP
To enable ARP learning via gratuitous ARP, use the following command.
• Enable ARP learning via gratuitous ARP.
CONFIGURATION mode
arp learn-enable
ARP Learning via ARP Request
In Dell Networking OS versions prior to 8.3.1.0, Dell Networking OS learns via ARP requests only if the target IP specified in the packet
matches the IP address of the receiving router interface. This is the case when a host is attempting to resolve the gateway address.
If the target IP does not match the incoming interface, the packet is dropped. If there is an existing entry for the requesting host, it is
updated.
Figure 46. ARP Learning via ARP Request
Beginning with Dell Networking OS version 8.3.1.0, when you enable ARP learning via gratuitous ARP, the system installs a new ARP entry,
or updates an existing entry for all received ARP requests.
Figure 47. ARP Learning via ARP Request with ARP Learning via Gratuitous ARP Enabled
IPv4 Routing
403