Users Guide

127772672 21936128 dosFs2.0 USERFLASH rw slot0:

- - - network rw ftp:

- - - network rw tftp:

- - - network rw scp:

You can change the default file system so that file management commands apply to a particular device or memory.

To change the default directory, use the following command.

• Change the default directory.

EXEC Privilege mode

cd directory

View Command History

The command-history trace feature captures all commands entered by all users of the system with a time stamp and writes these

messages to a dedicated trace log buffer.

The system generates a trace message for each executed command. No password information is saved to the file.

To view the command-history trace, use the show command-history command.

Example of the show command-history Command

Dell#show command-history

[12/5 10:57:8]: CMD-(CLI):service password-encryption

[12/5 10:57:12]: CMD-(CLI):hostname Force10

[12/5 10:57:12]: CMD-(CLI):ip telnet server enable

[12/5 10:57:12]: CMD-(CLI):line console 0

[12/5 10:57:12]: CMD-(CLI):line vty 0 9

[12/5 10:57:13]: CMD-(CLI):boot system rpm0 primary flash://FTOS-CB-1.1.1.2E2.bin

Upgrading Dell Networking OS

NOTE

: To upgrade Dell Networking Operating System (OS), refer to the Release Notes for the version you want to load on the

system.

Using HTTP for File Transfers

Stating with Release 9.3(0.1), you can use HTTP to copy files or configuration details to a remote server. To transfer files to an external

server, use the copy source-file-url http://host[:port]/file-path command.

Enter the following source-file-url keywords and information:

• To copy a file from the internal FLASH, enter flash:// followed by the filename.

• To copy the running configuration, enter the keyword running-config.

• To copy the startup configuration, enter the keyword startup-config.

• To copy a file on the USB device, enter usbflash:// followed by the filename.

In the Dell Networking OS release 9.8(0.0), HTTP services support the VRF-aware functionality. If you want the HTTP server to use a

VRF table that is attached to an interface, configure that HTTP server to use a specific routing table. You can use the ip http vrf

command to inform the HTTP server to use a specific routing table. After you configure this setting, the VRF table is used to look up the

destination address.

NOTE

: To enable HTTP to be VRF-aware, as a prerequisite you must first define the VRF.

You can specify either the management VRF or a nondefault VRF to configure the VRF awareness setting.

Getting Started