Administrator Guide

attacker’s MAC address and the gateway’s IP address. The client then thinks that the attacker is the gateway, and sends all internet-
bound packets to it. Likewise, the attacker sends the gateway an ARP message containing the attacker’s MAC address and the client’s IP
address. The gateway then thinks that the attacker is the client and forwards all packets addressed to the client to it. As a result, the
attacker is able to sniff all packets to and from the client.
Other attacks using ARP spoofing include:
Broadcast An attacker can broadcast an ARP reply that specifies FF:FF:FF:FF:FF:FF as the gateway’s MAC address,
resulting in all clients broadcasting all internet-bound packets.
MAC flooding An attacker can send fraudulent ARP messages to the gateway until the ARP cache is exhausted, after which,
traffic from the gateway is broadcast.
Denial of service An attacker can send a fraudulent ARP messages to a client to associate a false MAC address with the gateway
address, which would blackhole all internet-bound packets from the client.
NOTE: Dynamic ARP inspection (DAI) uses entries in the L2SysFlow CAM region, a sub-region of SystemFlow. One CAM
entry is required for every DAI-enabled VLAN. You can enable DAI on up to 16 VLANs on a system.
Configuring Dynamic ARP Inspection
To enable dynamic ARP inspection, use the following commands.
1. Enable DHCP snooping.
2. Validate ARP frames against the DHCP snooping binding table.
INTERFACE VLAN mode
arp inspection
To view entries in the ARP database, use the show arp inspection database command.
DellEMC#show arp inspection database
Protocol Address Age(min) Hardware Address Interface VLAN CPU
---------------------------------------------------------------------
Internet 10.1.1.251 - 00:00:4d:57:f2:50 Te 1/2/1 Vl 10 CP
Internet 10.1.1.252 - 00:00:4d:57:e6:f6 Te 1/1/1 Vl 10 CP
Internet 10.1.1.253 - 00:00:4d:57:f8:e8 Te 1/3/1 Vl 10 CP
Internet 10.1.1.254 - 00:00:4d:69:e8:f2 Te 1/5/1 Vl 10 CP
DellEMC#
To see how many valid and invalid ARP packets have been processed, use the show arp inspection statistics command.
DellEMC#show arp inspection statistics
Dynamic ARP Inspection (DAI) Statistics
---------------------------------------
Valid ARP Requests : 0
Valid ARP Replies : 1000
Invalid ARP Requests : 1000
Invalid ARP Replies : 0
DellEMC#
Configuring dynamic ARP inspection-limit
To configure dynamic ARP inspection rate limit on a port, perform the following task.
1. Enter into global configuration mode.
EXEC Privilege mode
configure terminal
2. Select the interface to be configured.
CONFIGURATION mode
interface interface-name
3. Configure ARP packet inspection rate limiting.
INTERFACE CONFIGURATION mode
arp inspection-limit {rate pps [interval seconds]}
Dynamic Host Configuration Protocol (DHCP)
281