Users Guide

debug ipv6 nd ra–guard
Enable debugging for IPv6 RA guard snooping information.
Syntax
debug ipv6 nd ra-guard [interface_type slot/port | count value]
Parameters
interface_type slot/
port
Enter the one of the following interfaces and slot/port information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
count value Enter the keyword count then the number of debug outputs. The range is from 1 to
65534. The default is innity.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the C9010.
9.9(0.0) Introduced on the Z9500.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9000 switches.
device–role
Specify the role of the device attached to the port.
Syntax
device-role {host | router}
To reset the device role, use the no device-role {host | router} command.
Parameters
host Enter the keyword host to set the device-role as host.
router Enter the keyword router to set the device-role as router.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Neighbor Discovery Protocol (NDP) 1005