Users Guide

show ip ospf
Display information on the OSPF process congured on the switch.
S6000–ON
Syntax
show ip ospf [process-id | vrf vrf name]
Parameters
process-id Enter the OSPF Process ID to show a specic process. If no Process ID is entered,
command applies only to the rst OSPF process.
vrf vrf name Show only the OSPF information tied to the VRF process.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added output for LSA throttling timers.
8.3.7.0 Introduced on the S4810.
7.9.1.0 Added support for VRF.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area
0.
The following describes the show ip ospf command shown in the following example.
1084 Open Shortest Path First (OSPFv2 and OSPFv3)