Users Guide

Version Description
7.4.1.0 Introduced on the E-Series.
Usage Information
If you enable BFD at the global level, show ipv6 ospf interface shows the BFD provisioning.
If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD interval timers.
Example
Dell# show ipv6 ospf 3 interface tengigabitethernet 1/2/1
TenGigabitEthernet 1/2/1 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Interface is using OSPF global mode BFD configuration.
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5
Dell#
show ipv6 ospf neighbor
Display the OSPF neighbor information on a per-interface basis.
Syntax
show ipv6 ospf [process-number] [vrf vrf-name] neighbor [interface]
Parameters
process-number Enter the OSPF process number.
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display OSPF
neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are displayed.
interface
(OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults None
Command Modes
EXEC
EXEC Privilege
Open Shortest Path First (OSPFv2 and OSPFv3) 1153