Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
After you congure a unicast queue as strict-priority, that particular queue, on the entire chassis, is treated as a
strict-priority queue. Trac for a strict priority is scheduled before any other queues are serviced. For
example, if you send 100% line rate trac over the SP queue, it starves all other queues on the ports on which this
trac is owing.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to dene the QoS conguration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the trac this interface receives.
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p conguration on the interface, use the no dot1p-priority command.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
1228 Quality of Service (QoS)