Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series and C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
If trac is shaped between 64 and 1000 Kbs, for some values, the shaped rate is much less than the value
congured.
On 40-port 10G stack-unit if the trac is shaped between 64 and 1000 Kbs, for some values, the shaped rate is
much less than the value congured.
NOTE: When packets of size greater than 7000 bytes are expected to be received from the network,
Dell Networking recommends that you congure the burst value to be more than 175 KB if you
congured the rate shape. Such a setting ensures proper bandwidth sharing across queues.
Related Commands
• rate-shape — shapes trac output as part of the designated policy.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched trac on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
S6000–ON
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p trac is mapped to Queue 0 unless you enable the service-class dynamic dot1p command. The
default mapping is as follows:
dot1p Queue ID
0 1
1 0
2 2
3 3
4 4
5 5
6 6
Quality of Service (QoS) 1231