Users Guide
storm-control pfc in queue-drop-state clear
You can clear the queue-drop state on an interface where the PFC storm has been triggered.
Syntax
storm-control pfc in queue-drop-state clear
Parameters None
Defaults None
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage Information The storm-control pfc in queue-drop-state clear command is used to clear the queue-drop state
on a particular interface where the PFC storm has been triggered.
Example
Dell(conf-if-te-0/24)# storm-control pfc in queue-drop-state clear
disable storm-control pfc
You can disable the PFC storm globally.
Syntax
disable
Parameters None
Defaults None
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage Information The disable command is used to disable the PFC storm feature globally. By default, PFC storm feature is
enabled on all the interfaces on which "storm-control pfc in queue-drop" conguration has been applied.
Example Use the storm-control pfc command in the conguration mode to enter the 'storm-control-pfc'
conguration mode. The commands provisioned in this mode are applicable for all the interfaces that have PFC
storm enabled.
Dell(conf)#storm-control pfc
Dell(conf-storm-control-pfc)#disable
Storm Control 1517