Users Guide

Related Commands
• show dot1x interface — display the 802.1X conguration of an interface.
mac
Congure a list of supplicant MAC addresses for dot1x prole represented with a prole-name.
Syntax
[no] mac {mac-address1 mac-address2… mac-address6}
Parameters
mac-address1 mac-
address2… mac-
address6
Enter the keyword mac and type the 48– bit MAC addresses using the H.H.H format. A
maximum of 6 MAC addresses are allowed.
Defaults None
Command Modes
DOT1X PROFILE CONFIG (conf-dot1x-prole)
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, the Conguration Terminal Batch mode on C9010, Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The mac command congures a list of supplicant MAC addresses for a dot1x prole represented with a prole-
name. You can congure up to 6 MAC addresses in a single mac command. The maximum number of MAC
addresses that you can congure in a single prole is limited to 100.
Use this command in Conguration Terminal Batch mode to congure a list of supplicant MAC addresses for dot1x
prole in a dual-homing setup.
Example
Dell(conf)#dot1x profile mySupplicants
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit
dot1x mac-auth-bypass
Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, Dell Networking
OS attempts to authenticate the host based on its MAC address.
Syntax
dot1x mac-auth-bypass
802.1X 161