Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6000 ON

1611

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.

Usage Information To make the HTTP clients VRF-aware, use the ip http vrf command. The HTTP client uses the VRF name

that you specify to reach the HTTP server. If you do not specify a VRF name, the HTTP client uses the default

VRF.

ip route-export

Enables route leaking between VRFs. This command exports or shares IPv4 routes corresponding to one VRF with other nondefault VRFs.

Syntax

ip route-export tag [route-map-name]

Parameters

route-export Enter the keywords route-export to leak or share routes between VRFs.

tag Enter a tag (export route target) to expose routes to other VRFs. This tag acts as an

identier for exported routes. Use this identier while importing these routes into another

nondefault VRF.

route-map-name (Optional) Enter the name of the route-map to lter the exported routes.

You can leak global routes to VRFs. As the global RTM usually contains a large pool of

routes, when the destination VRF imports global routes, these routes are duplicated into

the VRF's RTM. It is mandatory to use route-maps to lter out leaked routes while sharing

global routes with VRFs.

Command Modes

• VRP mode

• CONFIGURATION mode