Users Guide

on the interface. This feature is particularly useful when looking for malicious trac. It is available for Layer 2 and
Layer 3 ingress and egress trac. You may specify trac using standard or extended access-lists. This mechanism
copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port
is the monitored port (MD) and the destination port is the monitoring port (MG).
Related Commands
• permit — congure a MAC address lter to pass packets.
• seq — congure a MAC address lter with a specied sequence number.
permit (for Standard IP ACLs)
To permit packets from a specic source IP address to leave the switch, congure a lter.
Syntax
permit {source [mask]| any | host ip-address} [count [byte]] [dscp value]
[order] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
Use the no permit {source [mask] | any | host ip-address} command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes. By default, ow-based monitoring is not
enabled.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
278 Access Control Lists (ACL)