Users Guide

boot write net cong retries
Set the number of retries for network boot conguration failure.
Syntax boot write net cong retries <int>
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Example
BOOT_USER # boot write net config retries 2
Updated number of Network Boot Config retries to 2
BOOT_USER #
boot zero
Erase the congured primary, secondary, or default boot image parameters. If you erase all three parameters, the S6000 switch boots from
its internal Flash.
Syntax
boot zero primary | secondary | default}
Parameters
primary
Enter the keyword primary to congure the boot parameters used in the rst attempt to
boot the system.
secondary
Enter the keyword secondary to congure boot parameters used if the primary operating
system boot selection is not available.
default
Enter the keyword default to congure boot parameters used if the secondary operating
system boot parameter selection is not available. You can congure this option to any of
the available type, for example ash/usb/ftp/tftp.
Defaults None
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
324 Boot Command Line Interface