Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
Usage Information
When you enter the reload command and the system reboots, you will not be prompted for a password to enter
the EXEC Privilege mode (normally you are required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-password command, you are prompted
for an enable password when you re-establish the session
Related Commands reload — Exit from this mode and reload FTOS.
ignore startup-cong
During a reload, do not load the startup-cong le.
Syntax ignore startup-cong
Defaults disabled
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage Information
Use this command if you have authentication procedures in the startup-cong other than the enable-password
setting.
interface management ethernet ip address
Assign an IP address to the Management Ethernet interface.
Syntax
[no] interface management ethernet ip address ip-address mask
To delete the IP address, enter no interface management ethernet ip address.
Defaults Not congured.
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
Boot Command Line Interface 327