Users Guide
When you enable outbound optimization, all peers receive the same update packets. Also, the next-hop address,
which is chosen as one of the addresses of the neighbor's reachable interface, is the same for all peers.
bgp recursive-bgp-next-hop
Enable next-hop resolution through other routes learned by BGP.
Syntax
bgp recursive-bgp-next-hop
To disable next-hop resolution, use the no bgp recursive-bgp-next-hop command.
Defaults Enabled
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage Information
This command is a knob to disable BGP next-hop resolution using BGP learned routes. During the next-hop
resolution, only the rst route that the next-hop resolves through is veried for the route’s protocol source and is
checked if the route is learned from BGP or not.
The clear ip bgp command is required for this command to take eect and to keep the BGP database
consistent. Execute the clear ip bgp command right after executing this command.
Related Commands
• clear ip bgp — clear the ip bgp.
Border Gateway Protocol 355