Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage Information
This command turns on BGP soft-reconguration inbound debugging. If no neighbor is specied, debug turns on
for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-name]
updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X |
peer-group peer-group-name] updates [in | out | prefix-list prefix-list-name]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view BGP
updates information corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prex-list prex-list-
name
(OPTIONAL) Enter the keyword prefix-list then the name of an established prex
list. If the prex list is not congured, the default is permit (to allow all routes).
Border Gateway Protocol 369