Users Guide

Usage Information
When you apply a route map to outbound routes, only routes that match at least one section of the route map are
permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used
in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound
policies on that peer.
neighbor route-reector-client
Congure the router as a route reector and the specied neighbors as members of the cluster.
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To remove one or more neighbors from a cluster, use the no neighbor {ip-address | peer-group-
name} route-reflector-client command. If you delete all members of a cluster, you also delete the
route-reector conguration on the router.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reector.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
A route reector reects routes to the neighbors assigned to the cluster. Neighbors in the cluster do not need not
to be fully meshed. By default, when you use no route reflector, the internal BGP (IBGP) speakers in the
network must be fully meshed.
Border Gateway Protocol 393