Users Guide
• hash-algorithm linecard 2 ip-sa-mask 00 ip-da-mask aa
The dierent hash algorithms are based on the number of Port Channel members and packet values. The default
hash algorithm (number 0) yields the most balanced results in various test scenarios, but if the default algorithm
does not provide a satisfactory distribution of trac, use the hash-algorithm command to designate another
algorithm.
When a Port Channel member leaves or is added to the Port Channel, the hash algorithm is recalculated to balance
trac across the members.
ip ecmp-group
Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are not congured,
the CAM can hold a maximum of 16 ecmp per route.
Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number} command.
Parameters
maximum-paths Specify the maximum number of ECMP for a route. The range is 2 to 64.
path-fallback Use the keywords path-fallback to enable this feature. If you enable the feature, re-
enter this keyword to disable the feature.
Defaults 16
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information You must save the new ECMP settings to the startup-cong (write-mem) then reload the system for the new
settings to take eect.
584 Equal Cost Multi-Path (ECMP)