Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Added support for 4093 VLANs on E-Series. Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information When creating an interface range, interfaces appear in the order they are entered; they are not sorted. The
command veries that interfaces are present (physical) or congured (logical).
Important Points to Remember:
• Bulk conguration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk conguration with a warning message.
• The interface range prompt includes interface types with slot/port[/subport] information for valid
interfaces. The prompt allows for a maximum of 32 characters. If the bulk conguration exceeds 32 characters,
it is represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port range is excluded from the
prompt.
• If overlapping port ranges are specied, the port range is extended to the smallest start port and the biggest
end port.
Example (Bulk)
Dell(conf)# interface range tengigbitethernet 2/10/1 - 2/11/2, fortyGigE 3/3,
tengigbitethernet 3/10/1
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Dell(conf)# interface range tengigbitethernet 1/10/1 - 1/12/4, fortyGigE
1/13/1, tengigbitethernet 1/15/1
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
Dell(conf)# interface range tengigabitethernet 1/1/1 - 1/12/3,
tengigabitethernet 1/3/2 - 1/9/4
Dell(conf-if-range-te-1/1/1-1/12/3)#
Example
(Overlapping Ports)
Dell(conf)# interface range tengigabitethernet 1/1/1 - 1/10/1,
tengigabitethernet 1/1/1 - 1/20/3
Dell(conf-if-range-te-1/1/1-1/20/3)#
Usage Information
Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel
commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-
channel interfaces that are not displayed in the show running-config command cannot be used with the bulk
conguration feature of the
interface range command. You cannot create virtual interfaces (VLAN, Port-
channel) using the interface range command.
676 Interfaces