Users Guide

Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.1.1.0 Introduced on the E-Series.
Usage Information When you congure keepalive, the system sends a self-addressed packet out of the congured interface to
verify that the far end of a WAN link is up. When you congure no keepalive, the system does not send
keepalive packets and so the local end of a WAN link remains up even if the remote end is down.
monitor interface
Monitor counters on a single interface or all interfaces. The screen is refreshed every ve seconds and the CLI prompt disappears.
Syntax
monitor interface [interface]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
• For the Management interface on the stack-unit, enter the keyword
managementEthernet then the slot/port information.
• For a port channel interface, enter the keyword port-channel and then a number.
•
For a Tunnel interface, enter the keyword tunnel then the slot/port. The range is
from 1 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
682 Interfaces